I am super excited about today’s post. I recently gave the guest room a bit of a facelift with some paint and art. My next step was to turn the office into a built in workspace… on a budget of $0. :: Challenge Accepted ::
Here’s the before:
And the glorious after:
And here’s a little instagram recap of how it all went down:
This project was actually much easier then I expected it to be, and I am very serious when I say if you have the right tools literally anyone can do this. I used a power drill, jigsaw, and palm sander and didn’t have any problems. And it is a one person job if you want or need it to be. In more detail:
- Remove the closet doors, the track, and the clothes rack. This took about 15 minutes, and I used a power drill on the track because the screws were really in there.
- The doors I had were only sort of hollow, they had what look like 2×2’s running in a zig zag in them so they were pretty sturdy. Using my jigsaw I cut one door down into cleats and the other into the length of the desk. I was lucky that even though the front of the doors had been painted white, the backside was still stained wood.
- The stain color that was already on the doors was extremely orange-y and had a few old paint marks on it, so I used my palm sander and 60 grit paper to dull it up. Then with a sanding block, I used 100 grit then 120 grit paper. I didn’t get it down to completely raw wood, but it turned out fine.
- I used a “stain and finish” on the door that became the desktop, in two thin coats, then let it dry for 24 hours. While drying, I installed the cleats. To figure out the height of the cleats I just measured the height of my husband’s desk, then mimicked it. I used wood glue on the cleats, then a power drill and wood screws to secure them to studs in the wall. One long cleat along the back wall, then smaller ones on the side. I would have done long ones on the side of the wall too, but there was only one stud on each side.
- I painted the wall with 1 coat of primer to seal in all the discoloration, then 1 coat of Sherwin Williams paint + primer (non tinted, just pure white)
- Using a rubber mallet, I tapped the desktop into place. It left a few small marks on the walls, but nothing big and easily touched up. Then, for a more finished look, I caulked all the cleats (for the top shelf that was already there and the desktop)
Whew! That’s a lot of words. Here’s some glamor shots:
The quote on is one I first read at The Lettered Cottage and just felt it was perfect so I stenciled it directly on the wall.
The bulletin board is spray painted and you can read about the chair redo here.
This desktop makes me infinitely happy. All the plugs/cords/electronic accessories are stored in those cute Liberty of London for Target canisters.
The top shelf is where all the pictures and books from the bookcase are now, and the bookcase is no longer in the room (which free up A LOT of space, because this is not a big room).
Come back Friday for some extra info on how I graffiti’d that quote on the wall & painted the bulletin board, as well as a source list on everything else!!
Be sure to follow along in between posts!